Molding Process Engineer(注塑成型工程师)

职位类别： 机械设计/制造工程师

Job Desciption：
1. Participate in new products pre-feasibility study such as product design improvement.
2. Coordinate with related division to design and improve robot clamp.
3. Participate in new products quote with related department and provide inputs based on molding capability and new product requirement.
4. Establish and update SAP data for molding and insert molding components.
5. Review mold flow report with related department and provide parameter recommendation and other suggestion for gate location, cooling channel location and etc.
6. Review mold design, products layout, cooling circuit design with related department.
7. Responsible for E-dart sensor type selection, trial run and verify during development process.
8. Establish and update E-dart profile template for mass production.
9. Responsible for following up mold fabrication and sample trial run in suppliers.
10. Responsible for optimizing process and support new tooling and equipment qualification.
11. Responsible for new products process development and optimizing, compile the trial run report and FOT workbook.
12. Collect and analyze process data, solve problems during trial run with cross functional team.
13. Release and update FOT workbook, Process Standard Parameter Sheet, Work Instruction, Products Material List and etc.
14. Compile and update process FEMA.
15. Monitor and improve pre-production process, solve pre-production issue.
16. Reduce PPM during pre-production.

Job Requirement：
1. BS degree or equivalent.
2. Major in Mechanical Engineering or Polymer Martial.
3. At least 2 years’ experience in molding process.
4. Familiar with polymer material properties.
5. Familiar with molding injection process.
6. Familiar with mold flow analysis.
7. Have ability to establish and optimize production process independently.
8. Have ability to solve issues in project development and production independently.

• 年龄要求： 不限
• 语言要求：不限